At first it seems a bit complicated but once you get the hold of it it’s pretty intuitive.ġ4 Once you are done with the sectioning of the “Ribbon”, select all the paths (Shift), head to the “Stroke Panel” and make the Stroke Cap and Corners “Rounded”.ġ5 - Hide or Delete the original “Text” layer by clicking on the small eye on the left side of its Thumbnail. Repeat with the other “End Points” in order to divide the letter sections.ġ3 - Keep dividing the “Ribbon” text in sections by cutting and joining the paths together. Use the “Selection Tool” (V) and “Shift” key to select the paths on each side of the letter and then use the “Direct Selection Tool” (A) to select just the “End Points” (one from each of the overlapping paths) and then “Join” them together. Check out each one and see where the “Ribbon” should be facing “Up” or “Down” and cut some of the edges to create individual “Pieces” of ribbon that will be colored differently.ġ2 Where the curved parts of the letters are (where the two paths overlap) use the “Scissors Tool” (C) to make cuts on each side of the overlap. You can also use the “Connect Selected Endpoints” button on the Top Menu to join selected paths together.ġ1 - Close the edges of the letters. We will use the “Scissors Tool” (C) to cut some spots in the overlapping paths and then “Join” some of them together to achieve the 3D effect. Repeat with the other side.ġ0 - Check the text and notice the spots where the “Ribbon” should overlap and where the “Curves” should be. The idea is to create the “Thickness” of the “Ribbon”.ĩ - Once you are happy with the placement, select the “Edges” of the first curved line with the “Direct Selection Tool” (A) (+ “Shift” key) and “Join” them together (Command/Control + J). If you need to “Close” the “Path” hit “Enter”.Ħ - Keep tracing the text and try to fit as much of it in a single “Path” making “Loops” and “Curves” and/or clicking again on top of a curved “End Point” to make it “Straight”.ħ - Use the “Direct Selection Tool” (A) to click on the “End Points” that need some fixing.Ĩ - Select all your “Paths” (Shift) and move the text “Up” and “Left” while holding the “Option/Alt” key to create a “Duplicate”. Use a different color for the “Stroke” to make it more visible against the refence text.ĥ - Start from the left edge of the “Document” and create a small curve that connects to the first letter. Lock this Layer by clicking to the left of its thumbnail and bringing out the small Padlock icon and “Create New Layer” by clicking on the button at the bottom of the “Layers Panel”.Ĥ - Use the “pen Tool” (P) to “Trace” the text. Or use the same options in the “Align Panel”. The Size will depend on your font and document.ģ - Center it using the “Horizontal and Vertical Align Center” options on your Top Menu and make sure that “Align to Artboard” is selected. If the “Rulers” are not enabled, go to View > Rulers > Show Rulers (Command/Control + R) to turn them ON.Ģ - Select the “Type Tool” (T), choose your font (we used “Learning Curve”) and type your text. For this tutorial, we will use the Free Font “Learning Curve” by Jess Latham as reference.ġ - In Illustrator, create a “New Document”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |